HID Fargo HDP8500 User Manual page 165

© 2012 HID Global Corporation. All rights reserved.
Nos.88 and 89)
Headlift Error
(PC Error Message
Nos. 102, 103, 104,
and 105, 291, 292,
293, 294)
Heater Error
(PC Error Message
No. 161,)
Output Hopper Full
(PC Error Message
No. 313)
Invalid Ribbon
(PC Error Message
No. 94, 95, 96)
Invalid Film
(PC Error Message
Nos. 164, 165, and
166,)
Internal Laminator
Error
PC Error Message
Nos. 257, 258)
Job Data Error
(PC Error Message
No. 106)
Lam Check Card
(PC Error Message
Nos. 213 )
Lam Async Error
HDP8500 Industrial Card Printer/Encoder User Guide
Printhead voltage.
This is a problem with the
Printhead Lift or Transfer
Roller Headlift.
The Transfer Heater Roller is
too hot.
Output Card Hopper is full to
capacity
An unauthorized Ribbon is
installed in the Printer.
The wrong Securemark
ribbon was installed in the
printer.
An unauthorized film is
installed in the Printer.
The print data sent to the
Printer is corrupt or has been
interrupted.
A jam occurred inside the
laminator
The Printer timed out waiting
for communication from the
technical assistance.
Remove ribbon and film cartridges.
Check for any obstructions in the
printhead area or mechanism.
Remove any obstructions. Cycle
printhead up and down from the
display. If printhead cycles normally,
reinstall cartridges.
Heater or RTD is malfunctioning.
Check heater and RTD connections.
If this problem persists, call for
technical assistance.
Empty the Hopper.
Get the correct Ribbon from your
dealer.
Get the correct Film from your dealer.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Reset the Printer and try again.
If this problem persists, call for
technical assistance.
Remove Card from Card Path. Make
sure there are no obstructions to the
Sensor, and recalibrate the Sensor.
Check Lam power/connections and
L001617 rev 1.1
165