Appendix; Status Display; B Channel Status Message Example - Polycom VSX Series Integrator's Reference Manual

Status Display

B Channel Status Message Example

© Polycom, Inc.
The call status can be displayed in a number of ways. The getcallstate command
shows a table listing the status, speed, and dialed number of current calls.
To display real-time status on individual B channels (incoming or outgoing calls),
either register the terminal session with the callstate register listen command,
described on page 3-45
on page 3-25. These two commands will cause the system to re-direct the B channel
status messages to the session which has issued one of these two commands. For
example, if the RS-232 device issues a dial or listen command, then call status is
directed to the RS-232 port; if a later session on a Telnet port issues a dial or listen
command, then call status is also directed to that Telnet port.
The following output example is for B channel status messages, where:
cs
RINGING
CONNECTED
BONDING
COMPLETE
Example:
->dial man 384 5551212 ISDN
Dialing manual
Dialing 5551212 384 none ISDN
cs: call[0] chan[0] dialstr[95551212] state[RINGING]
or start an outbound call with the dial command, described
Indicates call status for one B channel.
Indicates a ring-in or ring-out and is equivalent to a 25% blue
sphere on the graphical user interface.
Is equivalent to a 50% yellow sphere.
Indicates the bonding protocol is operational on the channel
and is equivalent to a 75% orange sphere.
Is equivalent to a 100% green sphere.

Appendix

Appendix - 1