Polycom VSX Series Integrator's Reference Manual page 145

Command Syntax
usepath- usepathnavigator
navigator <always|never|required|get>
Where:
• always: Always use PathNavigator
to place a multipoint call. Never use
the external MCU.
• never: Never use PathNavigator to
place a multipoint call. Use the
external MCU instead.
• required: This is the default. When
this option is selected, if the
multipoint call is within the MCU
capabilities, it is handled by the
MCU; otherwise, beyond the MCU
capabilities, it is handled through the
PathNavigator/MGC.
• get: Returns the current setting
(always, never, or required).
wake wake
webport webport <set|get> [N]
Where:
• set: Sets the web access port to N.
• get: Returns the current setting.
© Polycom, Inc.
Description
Selects the PathNavigator™
mode, if PathNavigator is used
with the system. Because
PathNavigator uses an MGC, it
can handle video conferences
with more participants and
higher speeds than an
embedded MCU.
PathNavigator, which supports
ad-hoc multipoint video
conferencing, is required to
implement Conference on
Demand™. Conference on
Demand allows users to bring
multiple endpoints together in a
video conference on an
unscheduled basis. It allows
users to place multipoint video
calls to remote participants by
only using their names and/or
numbers that correspond to
those remote locations.
Note: This option is only acces-
sible if PathNavigator is used.
User interface screen location:
System > Admin Settings >
Network > IP > H.323 Settings
(page 2): Use PathNavigator
for Multipoint Calls
This command wakes the
system from sleep mode. To put
the system in sleep mode, use
the sleep command on
page 3-84.
Specifies the port to use when
accessing the system using
VSX Web. If you change this
from the default (port 80), you
will need to include the port
number with the IP address
when you use VSX Web to
access the system. This makes
unauthorized access more
difficult.
User interface screen location:
System > Admin Settings >
General Settings > Security
(page 2): Web Access Port
Chapter 3 - System Commands
Example
usepathnavigator
required
wake
webport set 80
returns:
webaccessport 80
restart system for
changes to take
effect. restart
now? <y,n>
3 - 105