Polycom VSX Series Integrator's Reference Manual page 112

Integrator's Reference Manual for the VSX Series
Command Syntax
priareacode priareacode <set|get> ["area code"]
Where:
• set: Sets the PRI area code when
followed by the "area code"
parameter. To erase the current
setting, omit "area code".
• get: Returns the current setting.
• "area code": Numeric string
specifying the area code.
pricallbycall pricallbycall <set|get> [{0..31}]
Where:
• set: Sets PRI call-by-call when
followed by a value from {0..31}. To
erase the current setting, omit the
value.
• get: Returns the current setting.
{0..31}:
•
values.
3 - 72
Range of call-by-call
Description
Sets or gets the PRI area code.
User interface screen location:
System > Admin Settings >
Network > ISDN: Area Code
Note: This screen is only acces-
sible if you have a PRI network
interface connected to your
system.
Sets or gets the PRI area code.
Call-by-call is a number from 1
to 31, which is optionally sent to
an upstream telephone com-
pany switch, if required. For
example, specify a value of 6 for
a T1 PRI network interface
module that is directly con-
nected to an ATT 5ESS switch,
which is provisioned with Accu-
net. You must consult with the
telephone company service pro-
vider to determine whether a
call-by-call value is required for
a particular PRI line. For most
cases, the default value of 0 is
correct. Always use the value 0
when connected to a PBX. A
non-zero value should not be
required in Europe. Values
greater than 31 are reserved for
internal use and must not be
used.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 3):
Call-by-Call
Note: This screen is only acces-
sible if you have a PRI network
interface connected to your
system.
www.polycom.com/videodocumentation
Example
priareacode set
512
pricallbycall set
1