Polycom VSX Series Integrator's Reference Manual page 72

Integrator's Reference Manual for the VSX Series
Command Syntax
mpmode mpmode
<auto|discussion|presentation|full
screen|get>
Where:
• auto: In Auto mode, the system
switches between Full Screen Mode
and Discussion mode, depending on
the interaction between the sites. If
one site is talking uninterrupted for
15 seconds or more, the speaker
appears full screen.
• presentation: In Presentation
mode, the person who is speaking
appears full screen to the far sites,
while the person who is speaking
sees all the other sites on a split
screen.
• discussion: In Discussion mode
(also called Continuous Presence
mode), every site sees all the sites in
the meeting at the same time, on a
split screen.
• fullscreen: In Full Screen mode,
every site in the call sees the current
speaker, or the latest person to
speak, on the full screen.
• get: Returns the current setting for
this option.
numdigits- numdigitsdid <{0..99}|get>
did
Where:
• {0..99}: Specifies the number of
digits in DID numbers.
• get: Returns the current setting.
3 - 32
Description
Sets or gets the multipoint
conference viewing mode for the
system in a multipoint call. The
multipoint mode can be set to
auto, discussion, presentation,
or fullscreen. By default, it is set
to auto.
User interface screen location:
System > Admin Settings >
Monitors > Multipoint Setup:
Multipoint Mode
Sets the number of digits in the
DID Gateway number (E.164
dialing). The number of digits in
the DID is that portion of the full
DID that the Gateway will be
given from the ISDN service
provider as the Called Party
Line Identifier. This, in turn, will
be passed to the Gatekeeper for
address resolution.
User interface screen location:
System > Admin Settings >
Network > IP > H.323 Settings
(page 4): Number of Digits in
DID Number
Note: For this option to be avail-
able, the Gateway Number
Type on the same page must be
set to Direct Inward Dial.
www.polycom.com/videodocumentation
Example
mpmode discussion
numdigitsdid 7