Isdn Commands - Polycom VSX Series Integrator's Reference Manual

ISDN Commands

Command Syntax
areacode areacode <set|get>
areacode set ["code"]
Where:
• set: Sets the ISDN BRI area code
when followed by the area code
parameter. If you want to erase the
current setting, omit area code.
• get: Returns the area code
information.
• "code": Area code to use for all BRI
lines.
bri1enable, bri1enable <yes|no|get>
bri2enable,
bri2enable <yes|no|get>
bri3enable,
bri3enable <yes|no|get>
bri4enable
bri4enable <yes|no|get>
Where:
• yes: Enables the BRI line.
• no: Disables the BRI line.
• get: Returns the status of the BRI
line—yes if enabled, no if disabled.
briallenable briallenable <yes|no|get>
Where:
• yes: Enables all BRI lines.
• no: Disables all BRI lines.
• get: Returns the status of all BRI
lines—yes if enabled, no if disabled.
cts cts <normal|inverted|get>
Where:
• normal: Sets the signal to normal
(high voltage is logic 1).
• inverted: Sets the signal to inverted
(low voltage is logic 1).
• get: Returns the current setting
(normal or inverted).
dcd dcd <normal|inverted|get>
Where:
• normal: Sets the signal to normal
(high voltage is logic 1).
• inverted: Sets the signal to inverted
(low voltage is logic 1).
• get: Returns the current setting
(normal or inverted).
© Polycom, Inc.
Description
Sets the area code for all ISDN
BRI lines. This code is
associated with the area where
the VSX system is used.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Area Code (for Line 1, Line 2,
Line 3, and Line 4)
Enables or disables the ISDN
BRI line specified in the
command name.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Enable (for each line)
Enables or disables all ISDN
BRI lines.
User interface screen location:
System > Admin Settings >
Network > ISDN (page 2):
Enable (for Line 1, Line 2, Line
3, and Line 4)
Lets you configure the cts serial
interface control signal (clear to
send). The default setting for
this signal is "normal".
User interface screen location:
System > Admin Settings >
Network > IP > H.323 Set-
tings> V.35/RS-449/RS-530
(page 3): CTS
Lets you configure the dcd serial
interface control signal (data
carrier detect). The default
setting for this signal is "normal".
User interface screen location:
System > Admin Settings >
Network >
V.35/RS-449/RS-530 (page 3):
DCD
Chapter 3 - System Commands
Example
areacode get
returns information
similar to this:
areacode 212
bri1enable yes
briallenable yes
cts normal
dcd inverted
3 - 69