Polycom VSX Series Integrator's Reference Manual page 62

Integrator's Reference Manual for the VSX Series
Command Syntax
autoanswer autoanswer
<yes|no|donotdisturb|get>
Where:
• yes: Allows any incoming call to be
connected automatically.
This is the factory default setting.
• no: Prompts the user to answer
incoming calls.
• donotdisturb: Notifies the user of
incoming calls, but does not connect
the call. The site that placed the call
receives a Far Site Busy (H.320) or
Call Rejected (H.323) code.
• get: Returns the status of the option
(yes, no, or donotdisturb).
calldetailre- calldetailreport <yes|no|get>
port
Where:
• yes: Turns on call detail reporting.
• no: Does not generate Call Detail
Report.
• get: Returns the current setting (yes
or no).
callencryp- callencryption
tion <required|disabled|get>
Where:
• required: Sets call encryption to be
used for every call when it is
available.
• disabled: Disables call encryption.
• get: Returns the current setting
(required or disabled).
callprefer- callpreference
<h320|h323|both|get>
ence
Where:
• h320: Selects H.320 (ISDN) as the
supported call type.
• h323: Selects H.323 (IP) as the
supported call type.
• both: Selects both H.320 and
H.323.
• get: Returns the selected call types.
3 - 22
Description
Sets the Auto Answer Point to
Point mode, which determines
how the system will handle an
incoming call in a point-to-point
video conference.
User interface screen location:
System > Admin Settings >
General Settings > System
Settings > Call Settings: Auto
Answer Point to Point
Specifies whether to generate a
report of all calls made with the
system.
User interface screen location:
System > Admin Settings >
General Settings > System
Settings > Call Settings (page
2): Call Detail Report
Sets or gets the encryption
mode. Use encryption when the
far site is capable of encryption.
User interface screen location:
System > Admin Settings >
General Settings > Security:
AES Encryption
Note: The Encryption options
are only visible on the user inter-
face if an encryption key has
been entered.
Specifies the supported call
types (ISDN, IP, or both). After
making a change, you must
restart the system.
User interface screen location:
System > Admin Settings >
Network > Call Preference:
Enable IP H.323, Enable SIP,
and Enable ISDN H.320
www.polycom.com/videodocumentation
Example
autoanswer
donotdisturb
calldetailreport
yes
callencryption
required
callpreference
h323