Nec Dianascope; Notes - NEC Express5800/R320a-E4 User Manual

5-92 Installing and Using Utilities

NEC DianaScope

NEC DianaScope is software for remote management of NEC Express5800/ft series.
For features and installation of NEC DianaScope, see "NEC DianaScope Online Document" in
"NEC EXPRESSBUILDER."
TIPS:
To use NEC DianaScope with NEC Express5800/ft series, appropriate server license is required.
- UL1198- 001E DianaScope Additional Server License (1)
License for managing one server.
- UL1198- 011E DianaScope Additional Server License (10)
License for managing ten servers.
This server comes with one license of NEC DianaScope.

Notes

The online document provides general descriptions of overall servers to be remotely managed by
NEC DianaScope, but this section indicates notes that require special attention for remotely
managing this server using NEC DianaScope.
When remotely managing this server from NEC DianaScope, only LAN connection is
available. Direct connection and connection via modem are not supported.
NEC DianaScope cannot power off, power cycle or reset the server. NEC Express5800/ft
series does not support such functions.
Power supply state display is partly different from module POWER lamp on the device. Only
DC on(turn on green lamp) and DC off(turn off green lamp) correspond in NEC DianaScope.
When the communication with EXPRESSSCOPE Engine series becomes impossible by the
CPU/IO module turned AC off and the like, the LCD and the each lamp statement and so on
keeps previous state.