NEC Express5800/R320a-E4 User Manual page 66

2-30 General Description
Insert/Remove Floppy Disk
Connect the Flash FDD to the USB connector of this server.
The driver is automatically recognized, and it becomes possible to use this Flash FDD.
CHECK:
If you insert unformatted disk, you will see a message that the
disk cannot be read or that needs formatting. To format a floppy
disk, refer to your OS manual.
If you power on or restart NEC Express5800/ft series with the
Flash FDD connected, the server will access the floppy disk to
start the system. Unless a system exits on the Flash FDD, the
server will be unable to start.
Remove the Flash FDD by using Safely Remove Hardware and Eject media function that is OS
standard function.
CHECK:
Before removing the Flash FDD, ensure that access LED of the
Flash FDD is off. If you remove it while the LED is lit, the stored
data could be damaged.
Use of Flash FDD
Please handle the Flash FDD while noting the following:
Do not turn off the server while the access LED of the Flash FDD is blinking. Turning off
the server at this time can cause a failure or data corruption.
The Flash FDD is a consumable. If the Flash FDD causes an error, use a new Flash FDD.
The Flash FDD cannot be connected by way of a USB hub. Directly connect the Flash
FDD to a USB connector of the server.
Before touching the Flash FDD, discharge static electricity from your body by touching a
nearby metal object(such as a doorknob or aluminum frame)
Do not disassemble the Flash FDD.
Do not apply a strong force to the Flash FDD.
Do not place the Flash FDD on the area where temperature rises (such as directly exposed
to sunlight or near a heater).
Do not handle the Flash FDD while eating, drinking, or smoking. Also, be careful not to
get thinner, alcohol, or other corrosive substances on the Flash FDD.
Do not use the floppy disk in a dusty place.
Be careful when connecting the Flash FDD to the server.
After using the Flash FDD, disconnect it from the server.