NEC Express5800/R320a-E4 User Manual page 322

5-162 Installing and Using Utilities
Resetting the Upgrade Side Hardware
If the Upgrade Side system hangs up while the system is operating with the Split mode, you can
reset the Upgrade Side hardware by clicking [Reset] button.
By resetting the Upgrade Side hardware, the system recovers.
IMPORTANT:
1 Do not reset the Upgrade Side hardware on the following cases:
– When the Upgrade Side does not reboot properly.
– When the remote connection from Production Side to the Upgrade Side does not set up properly.
– When the Upgrade Side hangs up.
2. If you reset the hardware while the Upgrade Side is working properly, the Upgrade side may
not launch properly. If this occurs after resetting the hardware, press [Abort] button to
interrupt the Active Upgrade, then retry the Active Activate from the start.
3. Do not reset the hardware while split. If the hardware is reset while split, the spilt may fail. If
this occurs, select [Abort] button to interrupt the Active Upgrade, then retry the Active
Upgrade.