NEC Express5800/R320a-E4 User Manual page 111

When you stop the operation of a CPU module, the indications of the status LEDs change as
follows. Below denotes that the only one CPU module is operating.
[Indications of status LEDs]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
As an example, the indications of when CPU module 0 is stopped are shown.
Press the start button of the CPU module stopped by ft server utility.
3.
In the ft server utility, select the stopped CPU module and click [Up] of [Bring Up/Bring
Down].
Once the CPU module is started, hardware diagnosis and then synchronization of memory
(memory copy) are performed, and the duplication process is completed.
Note that the system is paused temporarily for copying memory during memory
synchronization.
[Indications of status LEDs after completion of duplication]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
IMPORTANT:
After duplication is completed, the FT LED illuminates in green.
Do not perform the evaluation of start and stop unless the above process is completed.
LED
LED
LED
LED
Windows Setup and Operation 3-41
Secondary
(Operating)
Green
Green
System
-
Secondary
(Operating)
Green
Green
System
Green
Primary
(Operating)
-
Green
Primary
(Operating)
-
Green