Optical Disk Drive - NEC Express5800/R320a-E4 User Manual

Optical Disk Drive

NEC Express5800/ft series has an optical disk drive on the front panel. It is a device used to
read/write data from an optical disk. Compared to a floppy disk/Flash FDD, an optical disk
allows for larger volume and fast data readout.
Observe the following instructions to use the server safely. There are risks of a
burn, injury, or damage to physical assets. For details, see "PRECAUTIONS
FOR SAFETY" in Chapter 1.
Do not leave the optical disk drive tray ejected.
Insert/Remove Optical Disk
Follow the steps below to set an optical disk.
1.
Before you insert an optical disk, make sure that the server is
powered on. When the server is powered on, the LED lights
in green.
2.
Press the tray-eject button located in the front of the optical
disk drive. The tray is then ejected.
3.
Hold the optical disk with its signaling side facing the tray.
4.
As shown in the figure on the right, place the optical disk on
the tray and press lightly on the center to lock.
5.
Push the front side of the tray gently to the drive-closed
position.
IMPORTANT:
If you hear noise while running the optical disk drive, reset
the optical disk.
General Description 2-31
CAUTION