NEC Express5800/R320a-E4 User Manual page 80

3-10 Windows Setup and Operation
Confirm that synchronizing disks are started and the DISK ACCESS LEDs and the
7.
display of RDR utility change as shown below:
Synchronizing
Source disk
Destination disk
RDR Virtual Disk
IMPORTANT:
When the partition does not exist on the disk, the DISK ACCESS LED is turned off on the
source disk and the destination disk, and the status become Online.
IMPORTANT:
The time required for synchronization varies depending on the partition size on the disk.
For a 40 GB partition, it takes about 50 minutes. When the partition does not exist on the
disk, the synchronization is completed immediately after the RDR is set, and Op State:
State changes to Duplex. However, when the dynamic disk is used, the time required for
synchronization depends on the disk size regardless of whether or not the partition exists
on the disk. For a 73 GB disk, it takes about 80 minutes.
If the system is rebooted during synchronization, the process cannot be completed. Do
not restart the system until the synchronization is completed.
DISK ACCESS
LED
Amber
(Blinking)
Amber
(Blinking)
RDR Utility
Op State: State
Simplex
Syncing
Simplex
Status
Resync x percent
(x=0, 4, 8, ..., 96)