Flash Fdd - NEC Express5800/R320a-E4 User Manual

Flash FDD

A Flash FDD is a device that has capacity compatibility with a floppy disk drive.
One Flash FDD can only be connected to a USB connector of this server. If other floppy disk
drive is connected to this server, be sure to disconnect it.
Be extremely careful not to lose the Flash FDD or have it stolen.
If the Flash FDD is lost, stolen, misappropriated, or fraudulently obtained,
there is a risk of leaking confidential information to a third party. NEC
assumes no responsibility for damages caused by leaking confidential
information in this way.
IMPORTANT:
The status of the write protection switch of the Flash FDD from
before it is connected to this server is applied. Therefore, flipping
this switch after connecting the Flash FDD has no effect. If it is
necessary to flip this switch during use, temporarily disconnect
the Flash FDD from the server, and then flip the switch.
Be careful not to accidently slide the write protection switch
while connecting the Flash FDD to or disconnecting it from the
server.
The drive letter of the Flash FDD may be displayed as B instead
of A. This does not affect the operation of the server. Use B drive
for the floppy disk drive.
Be careful not to operate the server with the Flash FDD
connected.
When the server process failover with the Flash FDD connected,
the Flash FDD might not operate normally. In that case, once
remove the Flash FDD, and reconnect to this server.
NOTE:
The Flash FDD is only intended as a temporary means of performing
processing, so do not use the Flash FDD to back up data.
Compensation for recorded data
NEC will not pay compensation for data recorded on the Flash FDD if the data is lost.
General Description 2-29
CAUTION