System Setup; Machine Settings - Xerox WorkCentre 3315DN User Manual

System Setup

System Setup

System Setup options enable you to customize settings which are specific to the machine, such as Date
& Time and Power Save.

Machine Settings

1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight System Setup and press OK. If necessary, enter the
Administrator's Password using the keypad. Refer to
instructions.
3. Press the up/down arrows to highlight Machine Settings and press OK.
The following Machine Settings options and settings are available:
Note: * indicates the factory default setting.
Option
Machine ID
Machine Fax No.
Date & Time
Clock Mode
Language
Default Mode
Metric Defaults
170 Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
Accessing the Setup Options
Description
Use this option to enter a name
for your machine.
Use this option to enter the fax
number for your machine.
When you set the time and date,
they are used in delay fax and
delay print options, and printed
on reports.
Note: If the machine's power is
cut off, you need to reset the
correct time and date once the
power has been restored.
You can set your machine to
display the current time using
either a 12-hour or 24-hour
format.
Use this option to set the
message display language.
Your machine is preset to Copy
mode. You can switch this
default mode between Fax mode
and Copy mode.
Use to set the machine to
display measurements in
millimeters or inches.
on page 154 for
Settings
• ID
• Fax:
• 00-00-0000 [MDY]
• 00:00 AM
• 12 Hours *
• 24 Hours
• English *
• List of Available Languages
• Copy *
• Scan
• E-mail
• Fax
• inches *
• mm