Network Settings
Network Settings
You may set up the network using the machine's display screen. Before doing that, you must have the
relevant information concerning the type of network protocols and computer system you use. If you
are not sure which setting to use, contact your System Administrator to configure this machine on the
network, or refer to the
1.
Press Machine Status on the control panel.
2.
Press the up/down arrows to highlight Network Settings and press OK. If necessary, enter the
Administrator's Password using the keypad. Refer to
instructions.
The following Network Settings options and settings are available:
Option
TCP/IPv4
TCP/IPv6
Ethernet Speed
802.1x
Wireless
(3325DNI only)
Clear Settings
Network
Configuration
Net Activate
Http Activate
3.
Press the up/down arrows to highlight the option required and press OK.
4.
Press the up/down arrows to highlight the setting required and press OK to save the selection.
178
Xerox WorkCentre 3315DN/3325DN/3325DNI
User Guide
System Administrator Guide
Select appropriate protocol and configure parameters
to use the network environment.
Select appropriate protocol and configure parameters
to use the network environment.
Configure the network transmission speed.
Use to enable 802.1x and CentreWare Internet
Services.
Use to enable the machine to be configured on a
wireless network connection.
Reverts the network settings to the default values.
Enables printing of the Configuration report.
Turns access to the Ethernet network on or off.
Enables Http on the machine giving access to the
embedded web page.
for instructions.
Accessing the Setup Options
Description
on page 154 for
Settings
•
DHCP *
•
BOOTP
•
Static
•
IPv6 Activate *
•
DHCPv6 Config
•
Automatic *
•
10Mbps Half
•
10Mbps Full
•
100Mbps Half
•
100Mbps Full
•
1Gbps Full
(3325DN/DNI only)
•
On
•
Off *
•
Wi-Fi ON/OFF
•
WPS Settings
•
WLAN Setting
•
WLAN Default
•
WLAN Signal
•
Clear? Yes / No
•
Print? Yes / No
•
On *
•
Off
•
On *
•
Off