Xerox WorkCentre 3315DN User Manual page 167

Option
Image TCR
Dial Mode
Toll Save
5. Press the up/down arrows to highlight the option required and press OK.
6. Press the up/down arrows to highlight the setting required or enter the correct information using
the keypad.
7. Press OK to save the selection.
8. Continue customizing the Sending options as required, then press Stop to return to Ready mode.
Receiving
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Fax Setup and press OK.
3. If necessary, enter the Administrator's Password using the keypad. Refer to
Options on page 154 for instructions.
4. Press the up/down arrows to highlight Receiving and press OK.
The following Receiving options and settings are available:
Note: * indicates the factory default setting.
Option
Receive Mode
Ring to Answer
Stamp RCV Name
Description
Enables or disables the printing of a transmission
report with a reduced image of the first page of the fax
that was sent.
Sets the dialling mode to either tone or pulse.
Note: May not be available in some regions.
Sends faxes at a preset toll-saving time to save on call
costs.
Description
You can select the default fax
receiving mode.
You can specify the number of
times the machine rings before
answering an incoming call.
This option allows the machine
to automatically print the page
number, and the date and time
of reception at the bottom of
each page of a received fax.
•
•
•
•
•
•
•
•
Xerox WorkCentre 3315DN/3325DN/3325DNI
Fax Setup
Settings
• On *
• Off
• Tone *
• Pulse
• Off *
• On
Accessing the Setup
Settings
Fax *
Tel
Ans
Fax
DRPD
1 - 7 Times
1 *
On
Off *
User Guide
167