System Setup - Xerox WorkCentre 3045 User Manual

System Setup

Use this menu to configure general settings of the printer. For example, time to Energy Saver mode,
alarm settings, and so on.
Item
Power Saver Timer
Auto Reset
Fault Timeout
Job Timeout
Clock Settings
Alert Tone
mm/inch
Low Toner Alert Msg
Power On Wizard
Maintenance
Use this menu to find firmware information, make adjustments, and reset defaults.
Description
Specifies the transitional time for Energy Saver Modes 1 and 2.
• Energy Saver Mode 1 (Low Power): 5–60 min. The default setting is 60 minutes.
• Energy Saver Mode 2 (Sleep): 1–60 min. The default setting is 1 minute.
For details, see Energy Saver Mode
Specifies the time the printer waits for further control panel input before resetting the
Copy, Scan, or Fax settings and returning to standby mode.
You can cancel a printing process when a fault occurs while printing. Set the time until the
print job is canceled:
• On: Specifies the amount of time that the printer waits for additional data before it
cancels the job. The default setting is 60 seconds.
• Off: Cannot cancel.
You can cancel a printing process when it fails to print after a specified amount of time.
Set the time until the print job is canceled:
• On: Specifies the amount of time that the printer waits before it cancels the job. The
default setting is 30 seconds.
• Off: Cannot cancel.
Specifies the date and time, and the format of the settings:
• Set Date and Time.
• Date Format: Select yy/mm/dd, mm/dd/yy, or dd/mm/yy.
• Time Format: Select 12H or 24H format.
• Time Zone: Allows you to set your time zone by geographic region.
Specifies what prompts an alarm when an error occurs in the printer, and sets the sound
volume to Off, Min, Middle, or Max:
• Panel Select Tone: The default setting is Off.
• Panel Alert Tone: The default setting is Off.
• Auto Clear Alert: The default setting is Off.
• Job Tone: The default setting is Middle.
• Alert Tone: The default setting is Middle.
• All Tones: The default setting is Off.
Set the units for the custom paper size to millimeters or inches.
• Millimeter (mm): The paper size is displayed in millimeters. The default setting is mm.
• Inch ("): The paper size is displayed in inches.
Turns the Low Toner alert message On or Off.
Turns the Power On Wizard On or Off.
on page 37.
WorkCentre 3045 Multifunction Printer
Features
31
User Guide