Removing A Pdb Cable - Sun Microsystems Sun Fire X4450 Service Manual

Installing Drive Cables in a SAS Configuration (Part 2)
FIGURE 5-16
5.8.3

Removing a PDB Cable

To remove a Power Distribution Board cable.
1. Prepare the server for service.
a. Power off the server.
b. Disconnect the power cord (or cords) from the power supply (or supplies).
c. Slide the server out of the rack.
5-24 Sun Fire X4450 Server Service Manual • November 2009
See Section 2.4, "Powering Off the Server" on page
See Section 2.4, "Powering Off the Server" on page
See Section 2.5, "Extending the Server to the Maintenance Position" on
page 2-5.
2-3.
2-3.