Installing The Drives Cage - Sun Microsystems Sun Fire X4450 Service Manual

5.2.2

Installing the Drives Cage

1. Connect the drive data cables.
Press the connector into its socket until it snaps into place.
2. Position the drives cage in the chassis, over its standoffs. (
FIGURE 5-4
3. Slide the drives cage back until the drives backplane engages with the paddle
card connector. (
4. Replace the No. 2 Phillips screws securing the drives cage to the chassis.
(
FIGURE 5-4
Two screws secure the drives cage to each side of the chassis.
5. Install the fan modules.
See
Installing the Drives Cage
FIGURE 5-4
[3])
Section 3.3.5, "Installing a Fan Module" on page
Chapter 5
[2])
Servicing Infrastructure Boards and Components
[1])
FIGURE 5-4
3-13.
5-7