Installing Hd Cables In A Sas Configuration - Sun Microsystems Sun Fire X4450 Service Manual

11. Lift the cables out of the chassis.
Removing Drive Cables in a SAS Configuration
FIGURE 5-14
5.8.2

Installing HD Cables in a SAS Configuration

To install two drive cables; Disk 0-3 and Disk 4-7 in a SAS configuration, do the
following.
1. Prepare the server for service.
a. Power off the server.
b. Disconnect the power cord (or cords) from the power supply (or supplies).
c. Slide the server out of the rack.
d. Attach an antistatic wrist strap.
e. Remove the top cover.
2. Remove the memory tray.
See
See Section 2.4, "Powering Off the Server" on page
See Section 2.4, "Powering Off the Server" on page
See Section 2.5, "Extending the Server to the Maintenance Position" on
page 2-5.
See Section 2.7, "Performing Electrostatic Discharge and Antistatic Prevention
Measures" on page 2-9.
See Section 2.8, "Removing the Top Cover" on page
Section 4.2.1, "Removing the Memory Tray" on page
Chapter 5 Servicing Infrastructure Boards and Components
2-3.
2-3.
2-11.
4-11.
5-21