Installing A Power Supply - Sun Microsystems Sun Fire X4450 Service Manual

Installing a Power Supply

FIGURE 3-14
3. Reconnect the power cord (or cords) to the power supply (or supplies).
Verify that the AC Present LED is lit.
4. Close the CMA, inserting the end of the CMA into the rear left rail bracket
(
FIGURE 3-12
5. Verify that the following LEDs are not lit:
Failure LED on the replaced power supply
Service Required LED
Front Service Required LED
Rear Service Required LED
Note – See
Section 1.4, "Sun Fire X4450 Server Rear Panel Features" on page 1-7
information about identifying and interpreting system LEDs.
6. Verify the status of the power supplies.
Solaris OS: At the -> prompt, type the show environment command.
).
Section 1.3, "Sun Fire X4450 Server Front Panel Features" on page 1-6
Chapter 3 Servicing Customer-Replaceable Devices
and
for more
3-19