Required Tools; Obtaining The Chassis Serial Number - Sun Microsystems Sun Fire X4450 Service Manual

For your protection, observe the following safety precautions when setting up your
equipment:
Follow all Sun cautions, warnings, and instructions marked on the equipment and
■
described in Important Safety Information for Sun Hardware Systems (816-7190).
Follow all cautions, warnings, and instructions marked on the equipment and
■
described in the Sun Fire X4450 Server Compliance and Safety Manual.
Ensure that the voltage and frequency of your power source match the voltage
■
and frequency inscribed on the equipment's electrical rating label.
Follow the electrostatic discharge safety practices as described in this chapter.
■
2.2

Required Tools

The Sun Fire X4450 server can be serviced with the following tools:
Antistatic wrist strap
■
Antistatic mat
■
No. 2 Phillips screwdriver
■
No. 1 flat-blade screwdriver (for battery removal)
■
Non-conducting stylus or pencil (to power on server)
■
2.3

Obtaining the Chassis Serial Number

To obtain support for your server, you need your chassis serial number. The chassis
serial number is located on a sticker on the front of the server, and another sticker is
located on the top of the server.
Note – You might be asked for your hardware serial number if you need service for
your system. To find the serial number of your system, use the ILOM command get
/SYS or see your Installation Guide or Service Manual.
2-2 Sun Fire X4450 Server Service Manual • November 2009