Table of Contents
Advertisement
Removing the SCSI Interface Board Cable and the IDE Cable From the System Board
FIGURE 4-5
b. Unplug the IDE cable from the system board and leave the cable attached at the
other end (
c. Unplug but do not remove the DVD power/I
SCSI interface board.
d. Unplug the bezel cables from the SCSI interface board and move them out of
the way.
10. Using a No. 2 Phillips screwdriver, loosen the two green captive screws at the
front of the system configuration card reader cluster (
11. Grasp the system configuration card reader cluster on the two green grip points,
lift up and remove (
The grip points are visible when viewed from the top of the system configuration
card reader cluster with the rotating service module open.
).
FIGURE 4-5
).
FIGURE 4-6
Chapter 4 Removing and Replacing Rotating Service Module Components
IDE cable
connector
SCSI interface
board cable
connector
2
C interface ribbon cable from the
FIGURE 4-6
).
63
Advertisement
Table of Contents
