Sun Microsystems Sun Fire X4450 Service Manual page 67

4. Push the FB-DIMM into the connector until the ejector tabs lock the FB-DIMM
in place.
If the FB-DIMM does not easily seat into the connector, verify that the orientation
of the FB-DIMM is as shown in
to the FB-DIMM might occur.
5. Repeat
6. Install the top cover.
See
7. Slide the server into the rack.
See
8. Reconnect the power cord (or cords) to the power supply (or supplies).
Verify that the AC Present LED is lit.
See
9. Power on the server.
See
Installing FB-DIMMs
FIGURE 4-5
Step 2 through Step 4
Section 6.1, "Installing the Top Cover" on page
Section 6.3, "Returning the Server to the Normal Rack Position" on page
Section 6.4, "Powering On the Server" on page
Section 6.4, "Powering On the Server" on page
. If the orientation is reversed, damage
FIGURE 4-5
until all replacement FB-DIMMs are installed.
Chapter 4 Servicing Motherboard Components
6-2.
6-5.
6-5.
6-4.
4-9