Check Required Hardware - Microscan MS-Q Imager User Manual

Check Required Hardware

Check Required Hardware

Parts List for MS-Q Imagers with Cabled Handle (H2):
• One MS-Q Imager
• One H2 Handle
• One 6 ft. USB cable (Quadrus models only)
Note: PS/2 and RS-232 cables are optional and must be purchased separately.
• One Cable Clamp
• Two 2-56 x 5/16" screws, hex head, 1.5 inch-pounds (for Cable Clamp)
• Two 2-56 x 3/16" screws, hex head, 1.5 inch-pounds (for securing underside of imager
body to H2 Handle)
• Two 2-56 x 3/16" screws, hex head, 1.0 inch-pounds (for flexible 8-pin DIN connector at
back of handle)
Parts List for MS-Q Imagers with 1950 mAH Battery Handle (BH1) (Rev 5 and earlier only):
• One MS-Q Imager
• One BH1 Handle
• One 6 ft. USB cable (Quadrus models only)
Note: PS/2 and RS-232 cables are optional and must be purchased separately.
• One Cable Clamp
• Two 2-56 x 5/16" screws, hex head, 1.5 inch-pounds (for Cable Clamp)
• Two 2-56 x 3/16" screws, hex head, 1.5 inch-pounds (for securing underside of imager
body to H2 Handle)
Parts List for MS-Q Imagers with 3900 mAH Battery Handle (BH2):
• One MS-Q Imager
• One BH2 Handle
• One 6 ft. USB cable (Quadrus models only)
Note: PS/2 and RS-232 cables are optional and must be purchased separately.
• One Cable Clamp
• Two 2-56 x 5/16" screws, hex head, 1.5 inch-pounds (for Cable Clamp)
• Two 2-56 x 3/16" screws, hex head, 1.5 inch-pounds (for securing underside of imager
body to H2 Handle)
Parts List for MS-Q Imagers with Original Handle (H1):
• One MS-Q Imager
• One H1 Handle
• One 6 ft. USB cable (Quadrus models only)
Note: PS/2 and RS-232 cables are optional and must be purchased separately.
1-2
MS-Q Imager User's Manual