Reconnect Timeout - Microscan MS-Q Imager User Manual

Store If Not Connected
When this feature is enabled, the imager does not store data in non-volatile memory when
there is not an active connection to a host. When disabled, the imager follows normal
buffer operation.

Reconnect Timeout

When Auto Reconnect is enabled, the imager will reconnect to the host whenever there
is data to be sent, but only within the time limit (in seconds) set for Reconnect Timeout.
See also Transferring and Deleting Data
Max Connection Wait Time
When a connection from the imager to the host is explicitly requested (such as when a
Bluetooth Quick Connect Code is read), the imager will attempt a connection for the
amount of time (in seconds) set for Max Connection Wait Time.
Background Bluetooth Connection
Background Bluetooth Connection allows the user to begin decoding symbol data
before a Bluetooth connection is established.
When this feature is disabled, the Bluetooth connection must be confirmed before decoding
can begin.
Beep Before Bluetooth Connection
When this feature is enabled, a second beep is emitted while reading the Bluetooth Quick
Connect Code, but before the Bluetooth connection is established.
When this feature is disabled, the second beep is emitted upon connection to the Bluetooth
Modem.
MS-Q Imager User's Manual
on page 4-18.
Communications
4-27