Sensor And Printhead Data/Power Cable Clamp; Sensor And Printhead Data/Power Cable Clamps - Printronix T4204 Maintenance Manual

Chapter 4
Removal Procedures

Sensor And Printhead Data/Power Cable Clamp

To clamp the sensor and printhead data/power cables, follow the steps below
and refer to Figure 31.
1. Remove the top cover assembly (page 52).
2. Bundle the sensor cables (1), printhead data/power cable (2), and the
label taken cable (3) in the cable clamp (4).
3. Screw the cable clamp (4) to the standoff (5).
96