Chapter
4
Removal Procedures
Control Panel Assembly
To remove the control panel assembly, follow the steps below and refer to
Figure 15.
1. Remove the top cover assembly (page 52).
2. Open the front door of the printer.
3. Disconnect the control panel cable (1) from the back of the control panel
assembly (2).
4. Remove the two screws (3) securing the control panel to the front panel of
the printer.
5. Remove the control panel assembly (2).
6. After installing the control panel, check and adjust cable clearances
before operating the printer. (See page 94.)
7. Install the top cover assembly.
66