4
Removal Procedures
This chapter contains removal procedures for components that you can
replace at the field service level of maintenance.
If replacement or installation of a component or assembly differs from simply
reversing the removal steps, the differences are listed after the removal
procedure. It is important, therefore, to read the entire procedure before you
start maintenance.
Part numbers for replacement parts are listed in Chapter 5, "Illustrated Parts
Breakdown" (IPB). If a part does not have a part number in the IPB, it is not a
spared item.
WARNING
Always power the printer off and unplug the AC power cord before
doing any maintenance procedure.
Bevor Sie anfällige Wartungsarbeiten durchführen, müssen Sie zuerst
immer das Netzkabel aus der Steckdose ziehen. Wird das Netzkabel
nicht herausgezogen, können Verletzungen oder Geräteschäden
entstehen. Falls die Wartungsarbeit Stromzufuhr erfordert, wird im
Wartungsablauf darauf hingewiesen.
Required Tools
You do not need many tools and materials to service the T4204 printer:
•
Flat Tip Screwdriver
•
Phillips Screwdriver, #1 and #2
•
Hex keys: 1/16 inch, 5/64 inch, 3/32 inch, 1/8 inch
•
Torque Wrench with 1/4 inch hex receptacle and a range of 0-30 inch-
pounds
•
Nut Drivers: 7mm, 8mm, 1/4 inch
•
12R External Snap Ring Pliers
•
Loctite® 222 thread locker or equivalent
•
Pliers
Replacing Printer
Components
VORSICHT
49