Setting Up The T6 Rfid Printer; Media > Media Handling; Sensors > Control; Rfid > Control - Printronix T6000 Reference Manual

Setting up the T6 RFID Printer

Media > Media Handling
•
Continuous. Only forward media motion occurs. When the print job ends the trailing edge of the last
label printed remains at the TOF position under the printhead (not aligned at the Tear Bar). If the RFID
menu has Control > Tag Position set at a negative value, (ex., -0.2 inches), the printer will move in
reverse for a 0.2 inch distance as each tag is encoded. The last label printed will still remain at the TOF
position under the printhead (not aligned at the Tear Bar).
•
Tear-Off Strip. When a print job is sent, the leading edge of the first label will be pulled back to the TOF
position under the printhead. If the RFID menu has Tag Position set at a negative value, (ex., -0.2
inches), the printer will move in reverse for a 0.2 inch distance as each tag is encoded. When the print
job is complete the printer will place the trailing edge of the last printed label at the tear bar for easy
removal.
Sensors > Control
•
Gap. Select Gap sensing when a liner gap exists between die cut RFID labels.
•
Mark. Select Mark sensing when a black mark exists on the underside of the RFID label liner.
When the correct sensing is done, perform and Auto-Calibrate.
RFID > Control
•
RFID Active. Select Enable to enable the RFID encoder module.
•
Tag Type. Select the Tag Type that matches the inlay used on the desired media. When the proper
selection is entered, follow the display panel instructions for setting the antenna slide to the
recommended number position (1 thru 7). Refer to Selecting the Antenna Position on page 53.
57