Data Setting - FujiFilm Frenic-Mini Instruction Manual

3.4 Setting the Function Codes--"Data setting"
Menu #1 "Data setting" in Programming mode allows you to set function codes for making the
inverter functions match your needs.
To set function codes in Menu #1 "Data setting," it is necessary to set function code E52 data to 0
(Function code data setting) or 2 (Full-menu mode).
The table below lists the function codes available in the FRENIC-Mini. The function codes are
displayed on the LED monitor on the keypad as shown below.
Function code group
F codes
(Fundamental functions)
E codes
(Extension terminal
functions)
C codes
(Control functions of
frequency)
P codes
(Motor parameters)
H codes
(High performance
functions)
J codes
(Application functions)
y codes
(Link functions)
Refer to Chapter 5 "FUNCTION CODES" for details on the function codes.
Function codes that require simultaneous keying
To change data for function codes F00 (Protect data), H03 (Initialize data), and H97 (Clear alarm
data) simultaneous keying operation is necessary--
data from being lost by mistake.
Changing, validating, and saving function code data when the motor is running
Some function code data can be changed while the motor is running and some cannot. Further,
amongst the function codes whose data can be changed while the motor is running, there are
some for which the changes can be validated immediately and others for which they cannot. Refer
to the "Change when running" column in Chapter 5, Section 5.1 "Function Code Tables."
Function code group
Table 3.5 List of FRENIC-Mini Function Codes
Function code Function
F00 to F51 Basic
functions
E01 to E99 Terminal
functions
C01 to C52 Frequency
control
functions
P02 to P99 Motor
parameters
H03 to H98 High level
functions
J01 to J06 Application
functions
y01 to y99 Link functions
3-12
ID number in each function code group
To be used for basic motor running.
To be used to select the functions of
the control circuit terminals.
To be used to set functions related to
the LED monitor display.
To be used to set application func-
tions related to frequency settings.
To be used to set special parameters
for the motor capacity, etc.
To be used for high added value
functions and complicated control,
etc.
To be used for PID control.
To be used for communications
+ keys or
Description
+ keys. This prevents