FujiFilm Frenic-Mini Instruction Manual page 6

• Wire the three-phase motor to terminals U, V, and W of the inverter, aligning phases
each other.
Otherwise injuries could occur.
• The inverter, motor and wiring generate electric noise. Take care of malfunction of the
nearby sensors and devices. To prevent the motor from malfunctioning, implement noise
control measures.
Otherwise an accident could occur.
Operation
• Be sure to install the terminal block cover before turning the power on. Do not remove
the cover during power application.
Otherwise electric shock could occur.
• Do not operate switches with wet hands.
Doing so could cause electric shock.
• If the retry function has been selected, the inverter may automatically restart and drive
the motor according to some causes after tripping.
(Design the machinery or equipment so that human safety is ensured after restarting.)
• If the stall prevention function has been selected, the inverter may operate at an accel-
eration/deceleration time or frequency different from the set ones. Design the machine
so that safety is ensured even in such cases.
Otherwise an accident could occur.
• The STOP key is only effective when function setting (Function code F02) has been es-
tablished to enable the STOP key. Prepare an emergency stop switch separately. If you
disable the STOP key priority function and enable command (FWD) or (REV), you can-
not stop the inverter output by the STOP key on the built-in keypad.
• If an alarm reset is made with the operation signal turned on, a sudden start will occur.
Check that the operation signal is turned off in advance.
Otherwise an accident could occur.
• If you enable the "restart mode after instantaneous power failure" (Function code F14 =
4 or 5), then the inverter automatically restarts running the motor when the power is re-
covered.
(Design the machinery or equipment so that human safety is ensured after restarting.)
• If you set the function codes wrongly or without completely understanding this instruction
manual and the FRENIC-Mini User's Manual, the motor may rotate with a torque or at a
speed not permitted for the machine.
An accident or injuries could occur.
• Do not touch the inverter terminals while the power is applied to the inverter even if the
inverter stops.
Doing so could cause electric shock.
iv