FujiFilm Frenic-Mini Instruction Manual page 9

Conformity to the Low Voltage Directive in the EU (Continued)
11. Use wires listed in EN60204 Appendix C.
Appli-
cable
Inverter type
motor
rating
(kW)
0.1 FRN0.1C1 -2
0.2 FRN0.2C1 -2
0.4 FRN0.4C1 -2
0.75 FRN0.75C1 -2
1.5 FRN1.5C1 -2 **
2.2 FRN2.2C1 -2 **
3.7 FRN3.7C1 -2 **
0.4 FRN0.4C1 -4
0.75 FRN0.75C1 -4
1.5 FRN1.5C1 -4 **
2.2 FRN2.2C1 -4 **
3.7 FRN3.7C1 -4 **
4.0 FRN4.0C1 -4 **
0.1 FRN0.1C1 -7
0.2 FRN0.2C1 -7
0.4 FRN0.4C1 -7
0.75 FRN0.75C1 -7
1.5 FRN1.5C1 -7
2.2 FRN2.2C1 -7
Notes 1) A box ( ) in the above table replaces S or E depending on the enclosure.
2) A box ( ) in the above table replaces A, C, E, or J depending on the shipping destination.
3) Asterisks (**) in the above table denote the following:
21: Braking resistor built-in type; None: Standard
*1 The frame size and model of the MCCB or RCD/ELCB (with the exception of those exclusively
designed for protection from ground faults) will vary, depending on the power transformer capac-
ity. Refer to the related technical documentation for details.
*2 The recommended wire size for main circuits is for the 70C 600V PVC wires used at an ambient
temperature of 40C.
*3 Wire sizes are calculated on the basis of the input current under the condition that the power
supply capacity and impedance are 500 kVA and 5%, respectively.
*1
Rated current (A)
of
[L1/R, L2/S, L3/T]
MCCB or RCD/ELCB
*3
w/o DCR w/ DCR
w/ DCR
6
6
10
16
10
20
20 35
6
6
10
16
10
20
6
6
10
10 16
16 20
20 35
MCCB: Molded case circuit breaker
RDC: Residual-current-operated protective device
ELCB: Earth leakage circuit breaker
vii
Recommended wire size (mm
*2
Main circuit
power input
Inverter
output
[L1/L, L2/N]
[U, V,
Grounding [ G]
W]
*3
w/o DCR
2.5 2.5
2.5
4 4
2.5 2.5 2.5
2.5
2.5
2.5
4
4 6
2
)
*2
DCR
*2 Control
[P1,
circuit
P (+)]
(30A,
Braking
30B,
resistor
30C)
[P (+),
DB]
2.5 0.5
2.5 0.5
2.5
0.5
4