Recommended Wire Sizes - FujiFilm Frenic-Mini Instruction Manual

(2) Arrangement of the control circuit terminals (common to all FRENIC-Mini models)
30A
Terminal Screwdriver to be used
Phillips screwdriver
30A, 30B,
(JIS standard)
30C
No.1 screw tip
Phillips screwdriver for
precision machinery
Others
(JCIS standard)
No.0 screw tip
* Manufacturer of stick terminals: WAGO Company of Japan, Ltd. Refer to Table 2.5.
Screw size
M2
AWG24 (0.25 mm
AWG22 (0.34 mm
M2 or M2.5
AWG20 (0.50 mm
AWG18 (0.75 mm
The length of bared wires to be inserted into stick terminals is 5.0 mm or 8.0 mm for the short or long type,
respectively.
The following crimping tool is recommended: Variocrimp 4 (Part No.: 206-204).

2.3.3 Recommended Wire Sizes

Table 2.6 lists the recommended wire sizes. The wire size for the main circuit denotes the values
for HIV and IV solid wires proceeding and following a slash (/), respectively, at an ambient tem-
perature of 50C.
30B 30C
Screw size: M 2.5 Tightening torque: 0.4 N•m
Table 2.4 Control Circuit Terminals
Allowable wire size
AWG22 to AWG18
(0.34 to 0.75 mm
AWG24 to AWG18
(0.25 to 0.75 mm
Table 2.5 Recommended Stick Terminals
Wire size
Short type
2
)
2
)
2
)
2
)
Y1 Y1E FMA
11 12 13
Screw size: M 2 Tightening torque: 0.2 N•m
Bared wire
length
6 to 8 mm
2
)
5 to 7 mm
2
)
Type (216-
With insulated collar
Long type
321 301
322 302
221 201
222 202
2-4
C1 PLC X1 X2
11 CM FWD REV
Dimension of openings in
the control circuit termi-
nals for stick terminals*
2.7 mm (W) x 1.8 mm (H)
1.7 mm (W) x 1.6 mm (H)
)
Without insulated collar
Short type Long type
151 131
152 132
121 101
122 102
X3
CM