FujiFilm Frenic-Mini Instruction Manual page 39

If the jumper switch is set at SINK
As shown in Figure 2.15, you can
turn digital input terminals [X1] to
[X3], [FWD], and [REV] on or off
by open collector transistor out-
puts if you connect the power in-
put (+) of the external device such
as a programmable controller to
terminal [PLC] that supplies power
to the device.
To do so, switch the jumper to
SINK.
If the jumper switch is set at SOURCE
Connecting a relay to the inverter
Connecting a programmable controller to the inverter
Figure 2.16 (b) Programmable Controller Connection
Do not connect terminal [CM] of the inverter to a common terminal of a programmable
controller.
To turn terminals [X1] to [X3], [FWD], and [REV] on or off with relay contact input, use
reliable contacts free from poor contact.
Recommended relay: Fuji's control relay, Type: HH54PW
Figure 2.15 External Power Supply Connection
Figure 2.16 (a) Relay Connection
2-18