Table of Contents
Advertisement
3.5 Checking Changed Function Codes--"Data checking"
Menu #2 "Data checking" in Programming mode allows you to check function codes that have
been changed. Only data that has been changed from the factory defaults are displayed on the
LED monitor. You may refer to the function code data and change again if necessary. Figure 3.6
shows the status transition diagram for "Data checking."
To check function codes in Menu #2 "Data checking," it is necessary to set function code E52 data
to 1 (Function code data check mode) or 2 (Full-menu mode).
E 52
F 01.
* Pressing the
key when the
data is displayed will return to
Figure 3.6 "Data Checking" Status Transition (Changes made only to F01, F05, E52)
Basic key operation
The basic key operation is the same as for Menu #2 "Data setting."
3-15
Advertisement
Chapters
Table of Contents
