Terminal Function Assignment And Data Setting; Select Multistep Frequency; Select Acc/Dec Time -- Rt1 - FujiFilm FVR-Micro Instruction Manual

Terminal function assignment and data setting

 Select multistep frequency (0 to 15 steps) -- SS1, SS2, SS4, and SS8
(Function code data = 0, 1, 2, and 3)
The combination of the ON/OFF states of digital input signals SS1, SS2, SS4 and SS8 selects one of
16 different frequency commands defined beforehand by 15 function codes C05 to C19 (Multistep
frequency 0 to 15). With this, the inverter can drive the motor at 16 different preset frequencies.
The table below lists the frequencies that can be obtained by the combination of switching SS1,
SS2, SS4 and SS8. In the "Selected frequency" column, "Other than multistep frequency"
represents the reference frequency sourced by frequency command 1 (F01), frequency command
2 (C30), or others.
SS8 SS4
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF
OFF
OFF
OFF
ON OFF
ON OFF
ON OFF
ON OFF
ON
ON
ON
ON
 Select ACC/DEC time -- RT1 (Function code data = 4)
This terminal command switches between ACC/DEC time 1 (F07, F08) and ACC/DEC time 2
(E10, E11).
If no RT1 command is assigned, ACC/DEC time 1 (F07, F08) takes effect by default.
Input terminal command
RT1
OFF
ON
SS2
OFF
OFF
ON
ON
ON OFF
ON OFF
ON ON
ON ON
OFF
OFF
ON
ON
ON OFF
ON OFF
ON ON
ON ON
Acceleration/deceleration time 1 (F07, F08)
Acceleration/deceleration time 2 (E10, E11)
SS1 Selected frequency
OFF Other than multistep frequency
ON C05 (Multistep frequency 1)
OFF C06 (Multistep frequency 2)
ON C07 (Multistep frequency 3)
OFF C08 (Multistep frequency 4)
ON C09 (Multistep frequency 5)
OFF C10 (Multistep frequency 6)
ON C11 (Multistep frequency 7)
OFF C12 (Multistep frequency 8)
ON C13 (Multistep frequency 9)
OFF C14 (Multistep frequency 10)
ON C15 (Multistep frequency 11)
OFF C16 (Multistep frequency 12)
ON C17 (Multistep frequency 13)
OFF C18 (Multistep frequency 14)
ON C19 (Multistep frequency 15)
Acceleration/deceleration time
5-44