Table of Contents
Advertisement
Figure 3.3 shows the procedure for selecting the desired monitor item.
1
*
The speed monitor may display the output frequency (Hz), set frequency (Hz), load shaft speed (rpm),
line speed (m/min.), and constant rate of feeding time (min.) which can be selected by setting up func-
tion code E48.
2
*
These PID-related information will appear only when the inverter is under the PID control. (Refer to
Section 3.3.)
3
*
This will appear only when timer operation is enabled by setting up function code C21. (Refer to Chap-
ter 5.)
Figure 3.3 Monitor Item Selection Example
3-10
Advertisement
Chapters
Table of Contents
