Table of Contents
Advertisement
3.2.2 Programming Mode
Programming mode provides you with these functions--setting and checking function code data,
monitoring maintenance information and checking input/output (I/O) signal status. The functions
can be easily selected with the menu-driven system. Table 3.2 lists menus available in Program-
ming mode. The leftmost digit (numerals) of each letter string indicates the corresponding menu
number and the remaining three digits indicate the menu contents.
When the inverter enters Programming mode from the second time on, the menu that was se-
lected last in Programming mode will be displayed.
Menu #
Menu
#1
"Data setting"
"Data check-
#2
ing"
"Drive moni-
#3
toring"
#4
"I/O checking"
"Maintenance
#5
information"
"Alarm infor-
#6
mation"
#7
"Data copying"
Table 3.2 Menus Available in Programming Mode
LED
monitor
shows:
F codes
1.F_ _
(Fundamental functions)
E codes
1.E_ _
(Extension terminal functions)
C codes
1.C_ _
(Control functions of frequency)
P codes
1.P_ _
(Motor parameters)
H codes
1.H_ _
(High performance functions)
J codes
1.J_ _
(Application functions)
1.y_ _
y codes (Link functions)
Displays only function codes that have been
2. EP
changed from their factory defaults. You may refer
to or change those function codes data.
Displays the running information required for
3.oPE
maintenance or test running.
Displays external interface information.
4. _o
Displays maintenance information including accu-
5.CHE
mulated run time.
Displays the latest four alarm codes. You may refer
6.AL
to the running information at the time when the
alarm occurred.
Allows you to read or write function code data, as
7.CPy
well as verifying it.*
* To use this function, you will need a remote keypad (option).
3-3
Main functions
Selecting each of
these function
codes enables its
data to be dis-
played/changed.
Refer to:
Section
3.4
Section
3.5
Section
3.6
Section
3.7
Section
3.8
Section
3.9
--
Advertisement
Chapters
Table of Contents
