Enabling/Disabling Sending Of Snmp Traps On A Port - ZyXEL Communications MES3500-24S User Manual

Table 181 Management > Access Control > SNMP > Trap Group (continued)
LABEL
Apply
Cancel

42.3.6 Enabling/Disabling Sending of SNMP Traps on a Port

From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to set
whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 230 Management > Access Control > SNMP > Trap Group > Port
The following table describes the labels in this screen.
Table 182 Management > Access Control > SNMP > Trap Group > Port
LABEL
Option
Port
*
Active
Apply
Cancel
Chapter 42 Access Control
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the sending of SNMP traps on this port. The Switch sends the
related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500-24S/MGS3520 Series User's Guide
356