Enabling/Disabling Sending Of Snmp Traps On A Port - ZyXEL Communications GS2210 Series User Manual

The following table describes the labels in this screen.
Table 142 Management > Access Control > SNMP > Trap Group
LABEL
Trap Destination
IP
Type
Options
Apply
Cancel

37.3.2 Enabling/Disabling Sending of SNMP Traps on a Port

From the SNMP > Trap Group screen, click Port to view the screen as shown. Use this screen to
set whether a trap received on the port(s) would be sent to the SNMP manager.
Figure 214 Management > Access Control > SNMP > Trap Group > Port
GS2210 Series User's Guide
DESCRIPTION
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Traps on page 307 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category's check box automatically clears
all of the category's trap check boxes (the Switch only sends traps from selected
categories).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 37 Access Control
SNMP
299