Addition Of Protocols For Firmware Update - Fujitsu SPARC Enterprise T5140 Product Notes

How to obtain the host console in System Firmware 7.2.8 or later is as follows.
-> show /HOST/console
/HOST/console
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started.
XXXXXX console login:

Addition of Protocols for Firmware Update

In System Firmware 7.2.8 or later, three protocols which can be used in the firmware update
via the ILOM CLI interface have been added. In addition to the conventional tftp, you can
use ftp, sftp, and scp.
The scp protocol execution example:
-> load -source
scp://xxxxx:xxxxxx@XXX.XXX.XXX.XXX//mnt1/Firmware_Update/Huron/7.2.8/
/Sun_System_Firmware-7_2_8-SPARC_Enterprise_T5120+T5220.pkg
NOTE: An upgrade takes several minutes to complete. ILOM will enter a special
mode to load new firmware. No other tasks can be performed in ILOM until the
firmware upgrade is complete and ILOM is reset.
Are you sure you want to load the specified file (y/n)? y
Do you want to preserve the configuration (y/n)? y
................................................................
.......................................................
Chapter 2
Targets:
history
Properties:
escapechars = #.
line_count = 0
pause_count = 0
start_from = end
Commands:
cd
show
start
stop
Important Information About the SPARC Enterprise T5140 and T5240 Servers
To stop, type #.
7