Fujitsu SPARC Enterprise T5140 Product Notes page 76

Fixed Solaris OS Issues (Continued)
TABLE A-2
CR ID Description
6581309 Console behavior on the control domain is
inconsistent when a graphics device and keyboard are
specified for console use. This situation occurs when
the OpenBoot variables input-device and
output-device are set to anything other than the
default value of virtual-console.
If the control domain is set this way, some console
messages are sent to the graphics console and other
messages are sent to the virtual console. This
situation results in incomplete information on either
console. In addition, when the system is halted, or a
break is sent to the console, control is passed to the
virtual console, which requires keyboard input over
the virtual console. As a result, the graphics console
appears to hang.
6555956 Panic can occur during reboot with the message
Fatal error has occurred in: PCIe
root complex.
The panic occurs only on reboot and has never been
observed on the reboot that follows the panic.
6552999 If the verbose (-v) option is specified for the control
domain prtdiag command, additional
6731560
environmental status information will be displayed. If
Control-C is issued to interrupt the output of this
information, the picld(1M) daemon may enter the
state in which environmental status information is no
longer supplied to prtdiag. If it does, additional
environmental data will no longer be displayed.
6525647 Dynamic Reconfiguration (DR) of CPUs is disabled
for all logical domains that have any cryptographic
units bound to them
Boot Drive May Report "drive type unknown" for
Solaris format Command (CR 6886514)
This issue is resolved with Solaris patch ID 124630-32 or later.
66 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
Workaround
Note - Fixed in Solaris 10 10/08 and patch ID
137137-09 or later.
Use the virtual console only.
From the ok prompt, ensure that the default value of
virtual-console is set for both the input-
device and output-device variables.
If input-device and output-device are set to
graphics console and the graphics console
appears to be hung, connect to the virtual console
from the service processor in order to provide the
required input. Press Return on the virtual console
keyboard once to see the output on the virtual
console.
Note - Fixed in Solaris 10 5/08 or later.
Ensure that the system is set to automatically reboot
after a panic. For information about setting up
automatic reboot, see the Integrated Lights Out
Manager Supplement 2.0 for SPARC Enterprise
T5140 and T5240 Servers.
Note - Fixed in Solaris patch ID 138082-01 or
later, and 139502-02 or later.
See "If prtdiag Is Canceled, Subsequent
prtdiag Executions May Fail to Display Status
Information (CR 6552999, 6731560)" on page
Note - Fixed in Solaris patch ID 127111-10 or later.
To dynamically reconfigure CPUs in the control or
guest domains, remove all of the cryptographic units
bound to the domain. This can be done while the
system is running. The change will take effect after
the domain reboots.
73.