Fujitsu SPARC Enterprise T5140 Product Notes page 96

When you mount a Fujitsu 4Gbps Fibre Channel card and start the system, the 4Gbps Fibre
Channel card is falsely recognized as a F20 card in the ILOM CLI interface. Also, the slot
number is falsely displayed. In addition, the false recognition and the false display may
occur also in the FRU Status of the prtdiag -v command output.
Shown below is an event example in time of failure.
Configuration:
PCIE#0: Fibre Channel card
PCIE#1: void
PCIE#2: void
PCIE#3: void
PCIE#4: void
PCIE#5: void
The ILOM CLI interface output example:
/SYS/MB/RISER1/PCIE1/F20CARD
Properties:
FRU Status in the prtdiag -v command output:
# prtdiag -v
...
=========================== FRU Status ===========================
Location
------------------------------------------------------
...
SYS/MB/RISER1/PCIE1
...
Workaround: None. This can be safely ignored. To check the fibre channel card mount, use
IO Devices of the prtdiag command of Solaris OS.
The prtdiag command execution result:
# prtdiag
...
=========================== IO Devices ===========================
Slot +
Status
-----------------------------------------------------------------
86 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
type = F20 Card
ipmi_name = RSR1/PCIE1/F20
fault_state = OK
clear_fault_action = (none)
Bus Name +
Type Path
Name Status
F20CARD enabled
Model