Fujitsu SPARC Enterprise T5140 Product Notes page 49

Firmware and General Software Issues (Continued)
TABLE 3-4
CR ID Description
6849287 When powering on the system, there may be an
output message to show that the memory sensor
(VMEMR/VMEML) or the CPU core sensor
(VCORER/VCOREL) detected an excess of the
voltage over the threshold value of non-critical level.
Message Example:
Jun 10 04:58:31: IPMI
"ID = dcd : 06/10/2010 : 04:58:31 :
Voltage : /MB/V_VMEMR : Upper Non-
critical
going high : reading 1.84 >= threshold
1.66 Volts
Jun 10 04:59:17: IPMI
"ID = dd6 : 06/10/2010 : 04:58:44 :
Voltage : /MB/V_VMEMR : Upper Non-
critical
going low
1.66 Volts"
Jun 10 06:04:52: IPMI
"ID = de7 : 06/10/2010 : 06:04:52 :
Voltage : /MB/V_VCOREL : Upper Non-
critical
going high : reading 1.21 > = threshold
1.21 Volts"
Jun 10 06:05:36: IPMI
"ID = df0 : 06/10/2010 : 06:05:05 :
Voltage : /MB/V_VCOREL : Upper Non-
critical
going low
1.21 Volts"
6842745 The prtdiag command doesn't show the correct
memory configuration in the output, in the
configuration with different memory capacities.
For the output example, see
Command Doesn't Show the Correct Memory
Configuration in the Output, in the Configuration
with Different Memory Capacities (CR 6842745)" on
page 43.
|minor
|minor
: reading 1.60 <= threshold
|minor
|minor
: reading 1.16 < = threshold
"The prtdiag
Workaround
None.
This is not a problem as far as the value has been
restored to normal after detected the message of an
excess voltage over the threshold value.
:
:
:
:
None.
Please check that the memory size is equal to the
mounted memory size.
Chapter 3 Known Issues 39