Fujitsu SPARC Enterprise T5140 Product Notes page 105

Issues Fixed in System Firmware 7.2.7.b or Later (Continued)
TABLE A-8
CR ID Description
6822111 Pressing the FB-DIMM failure locator button on the
motherboard in response to a failure of a memory
module (FB-DIMM) that is connected to CMP1 may
cause the wrong LED to go on.
The list below shows which of the LEDs may go on
incorrectly.
- LEDs which go on incorrectly -
Failure location
---------------------------
/BR1/CH1/D0 --> /BR0/CH1/D0
/BR1/CH1/D1 --> /BR0/CH1/D1
/BR1/CH0/D1 --> /BR0/CH0/D1
/BR1/CH0/D0 --> /BR0/CH0/D0
/BR0/CH0/D0 --> /BR1/CH0/D0
/BR0/CH0/D1 --> /BR1/CH0/D1
/BR0/CH1/D1 --> /BR1/CH1/D1
/BR0/CH1/D0 --> /BR1/CH1/D0
6821325 In the output from the prtdiag command, warnings
may be displayed for input voltage sensors
(V_IN_MAIN) on power supply units.
For examples, see
Command, Warnings May Be Displayed (CR
6821325)" on page
6816507 After mounted the 10GbE XAUI card, when you
insert the power cord, the component information of
the 10GbE XAUI card does not appear on ILOM.
ILOM recognized the 10GbE XAUI card.
Incorrectly indicated location
"In the Output from the prtdiag
99.
Workaround
Note - Fixed in System Firmware 7.2.7.b or later.
None.
Perform parts replacement based on information
indicated by a command such as showfaults.
Note - Fixed in System Firmware 7.2.7.b or later.
None.
Ignore this issue because it is only a display error.
Note - Fixed in System Firmware 7.2.7.b or later.
None.
To confirm the component information of the 10GbE
XAUI card from ILOM, check it after you power on
the host.
Appendix A Fixed Issues 95