Fujitsu SPARC Enterprise T5140 Product Notes page 111

Issues Fixed in System Firmware 7.2.2.e or Later (Continued)
TABLE A-9
CR ID Description
6801248 For DC input power models, the following event log
might be repeatedly collected when the power to the
system is turned on:
Sample output from the showlogs command:
Chassis|minor:"Error getting status
DC volt for PS0"
Chassis|minor:"Error getting status
DC volt for PS1"
Chassis|minor:"Error getting status
DC volt for PS0"
Chassis|minor:"Error getting status
DC volt for PS0"
6794672 After the active replacement of PSU of the external
I/O expansion unit, even though the fan of the
replaced PSU is normal, a fan error is erroneously
detected.
6782508 The /SP/powermgmt/policy property has been
disabled.
Workaround
Note - Fixed in System Firmware 7.2.2.e or later.
None.
Ignore this event log.
Note - Fixed in System Firmware 7.2.2.e or later.
When this event occurred, execute the ILOM
command
(set /SYS/IOX@XX/PSX
clear_fault_action=true)
to clear the error information.
Note - Fixed in System Firmware 7.2.2.e or later.
To /SP/powermgmt/policy, the following
properties have become available.
- Performance
The system is allowed to use all the power that is
available.
- Elastic
The system power usage is adapted to the current
utilization level. For example, power up or down just
enough system components to keep relative utilization
at 70% at all times, even if workload fluctuates.
This property is enabled only in the logical domain
(LDoms) environment.
In case you are not in the logical domain (LDoms)
environment, or in case that the logical domain
(LDoms) configuration is the factory-default, the
property setting is available but cannot utilize its
power consumption control function.
Appendix A Fixed Issues 101