Fujitsu SPARC Enterprise T5140 Product Notes page 38

Hardware and Mechanical Issues (Continued)
TABLE 3-1
CR ID Description
6668745 The DC output value reported by the ILOM
V_DC_MAIN and OUTPUT_POWER properties (or by
the ALOM compatibility shell's
showpower –v and showenvironment
commands) for power supplies in SPARC Enterprise
T5240 server is incorrect. The reported value is
87.5% of the actual value. This issue does not affect
SPARC Enterprise T5140 server.
6654466 DRAM scrub errors can occur without producing
error reports.
6651885 A kernel panic can occur under any of four rare
hardware error conditions
• IngressHeaderBuffer (IHB) parity error
• EgressHeaderBuffer (EHB) parity error
• EgressDataBuffer (EDB) parity error
• Link-down transition
If any of these errors occur, then a software initiated
reboot of the domain will fail.
The failure symptom will be no that there is no PCI
device in the OpenBoot PROM device tree.
OpenBoot software will not be able to boot the
domain automatically.
6581309 To use the XVR-300 as a console of the SPARC
Enterprise T5xx0, patch 137111-01 or later must be
applied.
If the patch is applied after the OpenBoot PROM
(OBP) variable has been changed to use the XVR-
300 as the console, console output will revert to the
default ILOM console during the Solaris OS boot
sequence.
n/a An RJ45 cable may sometimes be difficult to
disconnect from an RJ45 port of an Ethernet card
mounted in the SPARC Enterprise T5140 server.
n/a XAUI card disables an On-board network port.
For details, see
Network Port" on page
28 SPARC Enterprise T5140 and T5240 Servers Product Notes • November 2012
"XAUI Card Disables an Onboard
31.
Workaround
Power the system off then power it on again from the
service processor. This action permits the automated
reboot to proceed normally. A diagnostic process will
run, identifying any faulty hardware.
To use the XVR-300 as a console, apply patch
137111-01 or later to the Solaris OS before changing
the OpenBoot PROM variable.
Alternatively, install the Solaris OS (or reinstall it)
with ILOM set as the console used, and then apply
the patch.
No GUI can be used during that time.
After the patch has been applied, the XVR-300 can
be used as the console as soon as the OpenBoot
PROM variable is changed.
In this event, disconnect the cable while keeping the
RJ45 cable connector tab depressed, such as with a
plastic card.