Fujitsu SPARC Enterprise T5140 Product Notes page 131

Firmware and General Software Events (Continued)
TABLE B-1
CR ID Description
6739602 If the logdetail property in
/SP/clients/activedirectory is set to a
value other than "none," the following authentication
error message may be displayed even if Active
Directory is set to disabled (state = disabled):
sc> ActDir | critical: (ActDir)
authentication status: auth-ERROR
6738510 Specifying the -t option in certain commands
(create, delete, exit, load, reset, set,
start, stop, version) may cause a forced logout
from the ILOM CLI.
6726663 In ILOM mode, or through access to the ILOM Web,
it may be possible to change the system time when
the system is powered on.
6723410 If you repeat in sequence a login to the service
processor, executing a command, and logging out,
logout may fail.
6659980 When you restarted Solaris OS, OpenBoot PROM
may output the error message "ERROR: Unable
to disown USB port 3."
For details, see
OpenBoot PROM May Output the Error Message
(CR 6659980)" on page
"When You Restarted Solaris OS,
126.
Workaround
If Active Directory is set to disabled, ignore the
message.
None.
In ILOM mode, be sure not to change the properties
displayed below at power on so as not to change the
system time directly or enable NTP services.
-> show /SP/clock
/SP/clock
Targets:
Properties:
datetime = Wed Dec
usentpserver = disabled
Commands:
cd
set
show
->
If this problem occurs, terminate the login session on
the client from which you have accessed the service
processor.
None.
This message has no impact on the system and the
USB device, and can be safely ignored.
Appendix B
3 06:22:48 2008
Minor Cases 121